| iPhone
3G - Jailbreak 2.2.1
Notes：
1．Before beginning: You must have iTunes 8 installed
and you must be on firmware 2.1, if you are not, be
sure to update via iTunes.
Also make sure to go into the task manager and disable
ANYTHING Apple or iTunes related.
2. WindowsXP user must download the NET Framework
version 2.0 （Click to download）
3. WindowsXP user should be sure" Control Panel "
－> " Administrative Tools " －> "Ｔelnet ,messenger
,terminal services" (Be sure three services are turned
on)
4.Download Firmware 2.2.1 (3G) （Click
to download）
Step 1
Make a folder on your desktop & name it Pwnage.Download
the Firmware 2.2.1 & Pwnage tool 2.2.5 &
place them in Pwnage folder you just created on
your desktop:Unzip/Unrar the QuickPwn2.2.5-2.zip
file inside the Pwnage folder.
Step 2
Launch iTunes and connect your iPhone 3G to the
computer via USB cable.
Select your iPhone from the list of devices on
the left side navigation bar. Now hold down
shift while clicking the Restore button.
Navigate to the Pwnage folder you created on your
desktop and select the 2.1 firmware ipsw file. Double
click the ipsw file or select it and click the Open
button to proceed.
Step 3
Once iTunes has finished upgrading your iPhone
3G to the 2.2.1 firmware you may launch QuickPwn
2.2.5 from the Pwnage folder you created on your
desktop.
Step 4
Make sure you iPhone 3G is still connected to the
computer via USB cable then click the blue arrow
to proceed.
Step 5
Click the Browse button to locate your iPhone 3G
firmware.
Step 6
QuickPwn will check to verify that the ipsw file
is valid. After completetion of the verification,
click the blue arrow button to proceed.
Step 7
Selecting（Add Cydia）
This step allows you select what you’d like installed
on your iPhone. You have the ability to select Cydia,
Installer, and replace boot logos. Once you have
made your selections click the blue arrow to continue
on. If you want a full jailbreaking experience,
installing Cydia and Installer is highly recommended
Step 8
QuickPwn will now ask you to confirm your iPhone
3G is still connected via USB cable before it continues.
Click the blue arrow button to proceed.
Step 9
QuickPwn will now automatically put your iPhone
into recovery mode. Once its in recovery mode you
will be prompted to: Hold the Home button for 5
seconds, Hold the Home and Power buttons for 10
seconds, then release the Power button and continuing
holding the Home button until your iPhone is in
DFU mode.
Step 10
Once QuickPwn detects your iPhone 3G in DFU mode
it will begin the jailbreaking process.
Step 11
Once jailbreaking is complete QuickPwn will inform
you that it was successfull.
|
